9 KN (+/- 5N) Lamination Hot Press (200x150 mm) up to 150C with Precision Pressure Controller - YLJHP80

• Max. Load: 9KN ( 900 Kg)
• Pneumatic cylinder travel distance 200 mm Max.
• Working area: 200 mm W x 150 mm D
• Max. working height: 0 - 110 mm
• Driven by any standard air compressor or inert gas tank, which is not included. 0.4~0.8Mpa of air pressure supply is needed. Please click the picture below to order.
• If alignment for upper and bottom plates is not ideal, please slightly adjust the four screws at corners.
•               
  
       
• Attention: If a gas cylinder is used instead of an air compressor(pic2), a two-stage pressure regulator(pic1) must be installed on the gas cylinder to limit the pressure within the required working range for safe operation. Click here to learn about the installation of a gas regulator.

Note: If used in the glove, an inert gas cylinder must be used for the gas source.

 pic1  pic2

Heating Plates

• Two heating plates with two independent single point temperature controllers 
• Single point PID temperature control with +/- 1ºC accuracy
• Heated plate area: 200 mm W x 150 mm D
• Max. working temperature: 200°C (continuous)
• Heating Rate: 10°C/ minute Max.
  
• Power: 208 - 240V V (50/60 Hz), 1200 W, Single phase
• To use at 110VAC, you need order a 1500W transformer ( Click picture left to order )

• Pneumatic cylinder bore size 125mm diameter.
• Digital pressure controller with PID tuning, which can keep the constant pressure at setting value.
• 30 segments programmable. (max working time: 9999 minutes for each segment)
• Pressure Accuracy: +/- 0.5 kg /cm2
• Optional: You may order the load cell below to calibrate the applied pressure force from time to time

• If the press is used in a glove box, two separate feed-throughs are required
• One feed-through for gas tubes.($295.00/set)
• One feed-through for power and communication cords.($500.00/set)
• The feed-throughs are not included in the standard package, please contact us for more information.

• CE approval
• NRTL or CSA certification is available upon request at an extra cost of $3500.00
• Calibration: Please use NIST certified load sensor to calibrate the pressure by yourselves. ( Please click the picture below to order:

• It can be used as a jig for compressing pressure adjustable split test cell, please click the picture below for details:

 compress-able coin cell Compress-able pouch cell