Faster Roll to Roll Transfer Coating System (400mm Width) for Pilot Scale of Battery Electrode - MSK-AFA-EI400

Working Voltage

• AC220V±10%, 50/60 Hz, three-phase
• AC380±10%, 50/60Hz, three-phase is available upon request

Max. Power Consumption

• 30 KW, the power for each heating chamber with 1.5 meter is around 9 kW.  
• Each heating chamber is suggested to connect separate power input. 
  

Coating Method

• Transfer coating method for better density and uniformity ( Pls click Pic below to see detail )
  

Max. Coating Width

• 400mm

Coating Speed

• Max. 4 meter / minute 

Thickness Precision

• ± 3µm (± 5µm at edges)

Max. Drying Temperature

• 150°C

Temperature Accuracy

• ±1°C

Heating Zone Length

• 4.5 Meter 3 zones 1.5 meters per zone )

Reeling/Unreeling Shaft

• 75mm (ID)

Max. Reeling/Unreeling Diameter

• 250mm (OD)

Max. Coating Length

• Depending on coating and substrate thickness.
• Typically, 10um thick foil with 100um coating can get 600 meters of electrode length coated per run

Slurry Stirring

• SS316 Moving Rod
  
  

Compressed Air

• 0.5-0.8 MPa (Air compressor not included. Please click here to order)
• Attention: If a gas cylinder is used instead of an air compressor(pic2), a two-stage pressure regulator(pic1) must be installed on the gas cylinder to limit the pressure within the required working range for safe operation. Click here to learn the installation of a gas regulator.

Optional 

• You may order Dual-Filtration System for NMP Vapor and connect it to the coating system for keeping environmentally healthy.

Compliance